Hi all,sorry i edited my question, i need to make REP with double link (4 ports, 2 ports each link, since 1 switch can have no more than two ports that belong to the same segment, so i will user port channel). i have several C9300 and need to make ri...
Hi all, i have many new 9200 IOS XE 16.12, as i read in guide i just need to plug laptop with ethernet cable to one of ethernet port of the switch, then will get dhcp ip then just open https://192.168.1.1. but in fact i need to console the switch the...
Hi all, i have upgrade CMS from 2.9 to 3.0 which, and since still theres is no deploy guide for 3.0 yet. i am using 2.9 guide for config, after deploy new webbridge3 (since in previous version was webbridge2 no longer active) i got problem.- callbrid...
Hi all,i have problem with jabber app on android or ios, i can sign in jabber normally, but always after few hours ( i didn't check exactly, but i thin over 6 hours) jabber app will got phone & messaging services dissconnected, and i check on diagno...
Hi nithi,thanks for reply, sure i already add the lic and cms into cmm, since it use traditional lic. and i have tested the cms by endpoint (means callbridge working), but my problem now is webbridge didn't working, it say C2W certificate cannot veri...
Hi sumi,you mean how to dial ? try call ip address of cms then get ivr, just enter space id and #or you mean call flow ? you can read on Cisco CVD document
Hi sumi,try this https://www.cisco.com/c/en/us/support/docs/conferencing/meeting-server/210441-H-323-SIP-on-CMS-Acano-Call-Bridge.htmlafter that you can simply make call from endpoint, cisco endpoint can call by URI (ie space_id@fqdn_of_cms or @ip_ad...
