I have seen this behavior as well, think it depends how the affected device is added to the Prime inventory. If you add the device via IP-Address, you don't see the hostname, but if you add it via DNS-Hostname (second field) it worked in my case.
Hi Thasleem
I'm facing the same situation - after a SSO failover to the secondary unit the landing-page didn't work anymore.
you wrote "I know that the pages doesn't get sync on HA, we need to break HA and copy the page on Secondary WLC"
where did yo...
HI @allI configured an "Fault - SNMP Trap forwarding" on LMS V4.2.5Is there any way to get rid of an entry ?There are five record lines where you can enter hostname, Port & community-string and an 'apply' button, but no 'delete'If I delete the values...
HiI got a very similar problem. We are using a 3 node HA-design (N+1)On the HA-device we got once a day the following trap-log message:0 Wed Oct 9 2013 21:03:36 RF Secondary Controller Usage notification TrapType: 3 DaysCounter :131 System Name :wlc...
Hmmm, this would make sense if the 5760 would run an IOS XE release equivalent to the AireOS V7.3.x (where HA was introduced) or higher - which is currently not the case ...