About Marek.Jiricek

Marek.Jiricek · 04-08-2013

Hello all,i'll appreciate any help with my DTMF issue, here is quick overview:Cisco IP Phone 7941 SCCP/SIP -> CUCM 8.6 -> GW Router 2801 (ipipgw 12.4(24)T8) -> ASA FW -> SIP Trunk provider.SIP Provider is using DTMF SIP INFO method (inband-voice in S...

Marek.Jiricek · 04-09-2013

Problem has been solved - matching for incoming dnis was different, to make it clear:1w6d: //-1/xxxxxxxxxxxx/DPM/dpAssociateIncomingPeerCore: Result=Success(0) after DP_MATCH_ORIGINATE; Incoming Dial-peer=31w6d: //-1/5131ED800000/DPM/dpAssociateInc...

Marek.Jiricek · 04-08-2013

I'll check it again, but when i debugged matching dial-peers last time, it was correct...see attach pls to find any mistakes.Thank you

Marek.Jiricek · 04-08-2013

RTP event from actually working 7940:1w6d: s=VoIP d=DSP payload 0x65 ssrc 0xE155D728 sequence 0x33E1 timestamp 0x1 FAC701w6d: << Pt:101 Evt:1 Pkt:0A 00 001w...

Marek.Jiricek · 04-08-2013

Well, that is always the question. But I dont think that is the correct way of looking on it. How do you explain all correctly working on 7940 with same setup?M.

Marek.Jiricek · 04-08-2013

Thanks for quick reply, but I've already tested more dtmf-relay setups in dial-peer. Now no change with that either, so post actual outputs isn't necessary.M.

Member Since	‎04-08-2013 06:03 AM
Date Last Visited	‎08-18-2017 04:03 AM
Posts	6

User Statistics

User Activity

DTMF missing in outbound calls, specific scenario

DTMF missing in outbound calls, specific scenario

Re: DTMF missing in outbound calls, specific scenario

Re: DTMF missing in outbound calls, specific scenario

DTMF missing in outbound calls, specific scenario

DTMF missing in outbound calls, specific scenario