Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About vvijaysa
08-18-2017
Stats
Member since
05-19-2012
89
Posts
129
Helpful
6
Solutions
09-06-2013
11:06 AM
Hey Daniel, Is your internet connection via a VPN Tunnel? If yes, try enabling NAT transversal. Thanks Vijay
... View more
09-06-2013
10:50 AM
Hello billetj01, What firmware are you running? We have had similar problems with old firmware. I guess upgrading firmware will solve the issue (the new one is 2.0.6.1). Let me know if it didn't work. Thanks Vijay
... View more
Created by
vvijaysa
in Small Business Wireless
in Small Business Wireless
09-06-2013
10:43 AM
09-06-2013
10:43 AM
Hello Thai, I assume your post is similar to the below post https://supportforums.cisco.com/message/4034910#4034910 No new firmware has been released even though it is anticipated. Please call the customer care at your country and register a case. Let me know if you need further help. Thanks Vijay
... View more
Created by
vvijaysa
in Small Business Security
in Small Business Security
09-06-2013
10:30 AM
09-06-2013
10:30 AM
Hey Kevin, Will you be able to share your topology so that we can see more detail. Thanks Vijay
... View more
Created by
vvijaysa
in Small Business Security
in Small Business Security
09-06-2013
10:24 AM
09-06-2013
10:24 AM
Hey Thomas, As the ping test went well, I assume may be it is a DNS problem. Check your DNS settings and try open DNS servers. Also, delete all the firewall/acl rules that you have set up and try accessing the site again. Let me know how it goes. Thanks Vijay
... View more
Created by
vvijaysa
in Small Business Switches
in Small Business Switches
08-09-2013
09:23 AM
08-09-2013
09:23 AM
Hello Ross, Try power cycling the device. If the problem remains, please contact SBSC support for further assistance. Thanks, Vijay
... View more
Created by
vvijaysa
in Small Business Switches
in Small Business Switches
08-09-2013
09:18 AM
08-09-2013
09:18 AM
Hi Shereef, FYI, all ports od SG300 are L2 ports. The only way you can do is Inter-VLAN routing. SG300 won't support routed ports. Thanks, Vijay
... View more
08-06-2013
05:51 PM
Thanks for the update Michael! Sent from Cisco Technical Support iPad App
... View more
08-06-2013
09:29 AM
Hi Michael, NSD fails means Network service detection failing on wan2. Under the dual wan settings, can you please tell me what is the NSD setting? Also, did you try swapping connection? In that way, we can determine whether it is a hardware issue? Sent from Cisco Technical Support iPad App
... View more
08-06-2013
09:02 AM
Hello Michael, Don't worry about the keep alive option? It is with PPPoE only. Can you swap the wap1 and wap2 connections and check the status? Also, what is your load balance parameters? Thanks, Vijay Sent from Cisco Technical Support iPad App
... View more
08-06-2013
08:23 AM
Hello Michael, I think the WAN2 connection has gone idle. What kind of connection you have in wan2? PPPoE.? If yes, change the connection timers to Keep Alive. Thanks Vijay Sent from Cisco Technical Support iPad App
... View more
08-02-2013
07:19 AM
Hello Tomasz, Yes. I guess you need to connect all APs to the switch (same bridged network). Clustering only makes all your AP act as one single entity ( you don't have to connect to the second AP In a cluster separately. Same wireless configuration will do). Refer Clustering section under the below manual for further details: http://www.cisco.com/en/US/docs/wireless/access_point/csbap/AP541N/administration/guide/AP541Nadmin.pdf#page139 Hope this helps, Vijay Please rate useful posts. Sent from Cisco Technical Support iPad App
... View more
Created by
vvijaysa
in Small Business Routers
in Small Business Routers
08-01-2013
03:17 PM
08-01-2013
03:17 PM
Hello Jared, Thanks for rating the answer. Yes, you can search for the term "Full tunnel" on the administration guides of RV routers. Also, search for "split-tunnel" support/"split-tunnel" mode (as if it has a split-tunnel option, turning it off means you are actually on full tunnel mode). Yes, RV220W and RV320 can support full tunnel-ing. Hope this helps, Vijay
... View more
Created by
vvijaysa
in Small Business Routers
in Small Business Routers
08-01-2013
09:04 AM
08-01-2013
09:04 AM
Hello Jared, I don't think RV180 supports full tunneling. Full tunneling allows you to route all your traffic through VPN. RV180 does only split-tunneling. Thanks, Vijay Sent from Cisco Technical Support iPad App
... View more
07-30-2013
03:11 PM
Hello, I think you can connect the switch through the router's wan port and set the switch's IP address as the default gateway for the router. Thanks, Vijay Please rate useful posts. Sent from Cisco Technical Support iPad App
... View more
Public Statistics
| Date Registered | 05-19-2012 12:41 PM |
| Date Last Visited | 08-18-2017 04:03 AM |
| Total Messages Posted | 89 |
| Total Helpful Votes Received | 129 |
Helpful Votes From
.JPG "bkohli_2"){kind=avatar}
