The steps worked perfectly. Thanks!

When set a port to be destination for SPAN traffic it will only collect information from a source and cannot be used a "normal" network traffic. So you will need to install a second NIC connected to another port on the switch on the VNC client comput...

This is what I got from both Cisco TAC and HP Support, "Upgrade to the next version of LMS." It should be available sometime in February. Kersean Rozier

These two lines are indicators of problems on the Serial line. 5813 interface resets <---This line is really HIGH12 carrier transitions Normally, my routers that have been up a year only have at most 3 interface resets.Kersean Rozier

Hi Hiro, Here is the infomation that I recieve from the Cisco.Com:The current version of OSPF MIB supported on Cisco devices does not support SNMP traps. There are no SNMP traps required for this procedure. I go this from the following weblink:http...