Since we've replaced our Internet router with a IOS-XE C8000 router, the ifHCOutCounters generate regular spikes like shown below.This happens normally when the router reboots and the counters are reset on the device and generate a wraparound in the...
Dear community,we're currently in the progress to migrate our N7K Fabricpath network to ACI.We follow of course the best-practices and connect N7K and ACI with L2out and L3out for migrating physical servers and SVIs in phases.However, our N7K just re...
I've recently figured, that we're also affected by this bug. We experienced too an ASA failover event due to "MIO-blade heartbeat failure" even though we're running a higher version than the one in the bug report: FXOS:2.11(1.154) / ASA:9.16(3).I've ...
Hi, we have a already established L3Out with BGP neighborship via Sub-Interfaces.We have to extend our IPv6 routing into ACI.On the counter side, the interface is configured dual-stack. So with an IPv4 and an IPv6 address.In ACI, I see no possibility...
Hi Community,
We've just purchased some ASR1001-HX devices and I'm facing a little issue while preparing the configuration
There is no ipv6 ospf authentication command:
Router(config)#int Gi0/0/0
Router(config-if)#ipv6 ospf ?
<1-65535> ...
I think I know now the impact. It seems we've now hit the line_full condition.It seems like expected. Anything destined beyond what's already in the MAC table is flooded on all links.We experience 2Gbps utilization on downlinks where nothing is conne...
Thanks Marcelo,However, I already know this document and read it thoroughly. However I coulnd't really find where its explaining the exact impact that happens when a MAC cannot be installed due to lines_full event.
Hey thanks for your answer.
I've "downgraded" to the current suggested Everest version.
But still no ipv6 ospf authentication interface-command.
I've played a bit with the licenses since I have advipservices active.
I've activated the adventservices...
