I recently moved the subnet 10.0.50.0/24 into a VRF. After doing so I realized this broke one of my NAT translations:ip nat inside source static tcp 10.0.50.230 22 interface GigabitEthernet1/1 9022I located the following document: http://www.cisco.c...
I recently moved the subnet 10.0.50.0/24 into a VRF. After doing so I realized this broke one of my NAT translations:ip nat inside source static tcp 10.0.50.230 22 interface GigabitEthernet1/1 9022I located the following document: http://www.cisco.c...
I am trying to get some experience with 6500 series switches so I bought a used 6504 and some cheap line cards on eBay to mess around with. I was surprised when I installed a WS-SVC-IPSEC-1 like card and got an error saying this is not supported.I gr...
I have Verizon FIOS 150/65 service. I recently upgraded my router from the stock Actiontec router provided by Verizon to a Cisco 3845. After the upgrade my up and down speeds are peaking at about 55Mbit/second. Prior to installing the 3845 I was m...
Hello, I am trying to have a simple EEM script triggered when a CPU spike is detected on the device... I have tried several combinations but here is where I stand.router#show run | sec resourceresource policy policy HIGHCPU global system cpu i...
Thanks for the quick reply. I tried an older image: Software (s72033_rp-IPSERVICESK9-M), Version 12.2(18)SXF17aAnd now I am getting this error:4 WS-SVC-IPSEC-1 79.38 1.89 - - on off (Linecard image not present)
Collisions have stopped incrementing completely but it seems to have nothing to do with my bandwidth problem. Anyone have thoughts as to what could be the culprit? Thanks!
When I set everything to auto it does auto-negotiate to 1000/full as it should. It also makes sense that the ISP's device is configured correctly since I am getting correct speeds with their router.Sent from Cisco Technical Support iPhone App
