About paulo.delgado

paulo.delgado · 07-07-2013

Hi,I've got a RV220W with firmware 1.0.4.17 connected to a Cisco EPC3000 modem from my cable provider.Previously I had a 60 Mbps connection to the Internet and I could achieve 57 to 59 Mbps throughput on my PC connected to the RV220W via a fast-ether...

paulo.delgado · 11-11-2013

Hi Tom,I don't believe that is the case. I have 100 Mbps bandwidth available from my ISP. If I connect a PC with a gigabit NIC to the RV220W, I get almost 100 Mbps throughput (ninety something). So I assume the modem is working correctly.If I then:1-...

paulo.delgado · 11-10-2013

I didn't get anything yet, I went back to the TP-Link my cable provider offered when I contracted the service.I am wating for the new Draytek 2925n+ (simultaneous WiFi dual band) and I convinced the local distributor to do a try & buy (one bad experi...

paulo.delgado · 10-15-2013

Hi Kriez,going from 100 Mbps to 28 Mbps on a LAN port is a lot worst than my own experience. I am sure you have done it, but you should check again for a possible duplex mismatch.Regarding the ticket I've opened with Cisco, they were able to reproduc...

paulo.delgado · 09-25-2013

Just a short update on this issue:I've got ticket "626722785 PT" still open with Cisco. After a long series of tests this ticket was escalated to level 2 support. They say that (and I quote) "the reason you are getting 98.2 mbps with the TP-link devi...

paulo.delgado · 08-17-2013

Not yet.I've been working with Cisco Technical Support performing a series of tests, but I am progressing a bit slowly now, as I am on holidays and the family needs more attention.Anyway, it looks like the problem is related to devices connected at 1...

Member Since	‎05-28-2013 04:58 AM
Date Last Visited	‎08-18-2017 04:03 AM
Posts	10

User Statistics

User Activity

RV220W - cannot get the router to use full bandwidth (was "RV220W slower after bandwidth upgrade")

RV220W - cannot get the router to use full bandwidth (was "RV220

RV220W - cannot get the router to use full bandwidth (was "RV220

RV220W - cannot get the router to use full bandwidth (was "RV220

RV220W - cannot get the router to use full bandwidth (was "RV220

RV220W slower after bandwidth upgrade