Make sure, that there is proper load balancing with a dialer threshold of 0. Another casue can be, the 2nd B Channel shoots, up, but due to inactive traffic it drops down. If the config is fine, then it is a general issue from Telco end also. But to ...
Hi, The config for now seems to be fine. If the Wic 1 AM is not picking up the phone, or gets disconnected after 1 or two rings, there is an IOS bug for ths. Also, AM cards are very prone to line noises, so make sure your line is clean. Assuming the...
Hi Andrew, You can put the dialout/chat script and, in that chat script you can specify the AT commands, which you want to put. To connect this dialout script to Am line, under the line, use, dialout script
Hi, Along with backup commands, you can also use the floating static routes. For eg.ip route 0.0.0.0 0.0.0.0 serial0/1 23ip route 0.0.0.0 0.0.0.0 dialer1 50This is the metric which we will give. The packets will go from link with lower mtric, but i...
Hi Jerry, As you clarified, that you are also not able to access the Router on the WAN IP either, so if it is the Cisco Router, then follow these steps. As a first step, if you are unable to (ping/ getting a host or network unreachable/not gett...