NormMuelleman

In simple terms:1. You want to lock-down PC's. You only want PC's that are authorized to be on the n...

The config on the switch does not affect the actual PC. It tells the switch what order to attempt to...

Greetings again;Have been getting alarms of database failures on the dashboard for ACS 5.4.0.46.2. F...

Are you trying to log in remotely to the device? The error you're getting is that the shared secrets...

I've been researching the differences between 4.2 and 5.4. There is a fundemental difference in the ...

Nope;I hit F5...it just sits with blank screen. After an extended period of time, it will finally po...

Hello all;I am trying to sort out a potential issue with ACS 5.4. I log into the primary ACS device ...

Curious to know the differences and hassles to upgrading from ACS 5.4 to 5.5. I know that there is a...

Let me set the scenario:PC1 is attached to access swtich on port 1/0/8. Port 1/0/8 was originally sw...

Greetings all! So, to start this discussion, I want to set up our network parameters so you have an ...

Ok, that makes total sense. So, further on that. Let's go back to square one; 1 is primary, 2 is sta...

We don't have pre-empt enabled. I did figure out when I plugged into the non-active sup engine on th...

Hello all once again;Today's question is concerning VSS and chassis movement. I've been reading up o...

I've been reading for 45 minutes since getting off night shift, trying to find a definitive answer t...

I've been having an argument with a "federal employee" about VOIP issues, MAC address port security,...