About Steve Fuller

Steve Fuller · 08-24-2015

Hi,I’ve been commenting on a discussion “Unable to configure SSH on the router” (https://supportforums.cisco.com/discussion/12587421/unable-configure-ssh-router) and had posted a reply to the original question.The original poster (OP) had added furth...

Steve Fuller · 03-20-2014

Hi,The points shown as awarded to an individual on the leader board have decreased since the migration to the new platform.Prior to the migration the points I had been awarded within the Data Centre forum was at 401, but since the migration this numb...

Steve Fuller · 03-19-2014

When viewing certain posts originated by other users, I'm presented with a banner at the top of the post stating "You posted this Discussion" and offering me the option to Edit or Delete the post.For example etherchannel between WS-C4506-E and stacke...

Steve Fuller · 08-10-2012

Hi,I'm trying to get ERSPAN working with an ERSPAN source on a Nexus 5548 and the ERSPAN destination on a Catalyst 6500.The configuration on the Nexus is as follows:[...]interface loopback0 ip address 192.168.2.133/32 ip router eigrp 1 ip pim spar...

Steve Fuller · 11-09-2015

Hi, What you show is a perfectable acceptable solution. The two vPC domains at the Nexus 9000 layer, vPC domain 117 and 118 in your diagram, have no knowledge of each other and so the same vPC and port-channel number may be used. As you've indicated,...

Steve Fuller · 11-09-2015

Hi, Unfortunately you can't "convert" or "breakout" the 40GE interfaces to get four 10 Gigabit Ethernet interfaces from each port. As per the Cisco Nexus 9300 Platform Switches Data Sheet: "The 40 Gigabit ports on the uplink module do not support the...

Steve Fuller · 11-06-2015

Hi Sheldon, You wouldn’t need to use the rate-mode dedicated command on the N7K-F248XP-25 as there’s no over-subscription between the ports on the module and the switch fabric. As per the Cisco Nexus 7000 F2-Series 48-Port 1 and 10 Gigabit Ethernet M...

Steve Fuller · 11-02-2015

Hi, It’s very likely that it will be technically possible to connect end systems to the spine layer, but whether it’s the “right” thing to do will depend upon what you’re trying to build and the reasons you’re building it. We know that spine-leaf net...

Steve Fuller · 10-30-2015

Hi This module has 12 Switch on Chip (SOC) with the 24 ports distributed across those. The distribution is port group 1-{Ports 1-2}, 2-{ Ports 3-4}, 3-{ Ports 5-6}….12-{23-24}. You can also see the port group members using the show interface capabili...

Member Since	‎06-23-2002 02:00 AM
Date Last Visited	‎11-15-2020 06:33 PM
Posts	852
Total Helpful Votes Received	1441

User Statistics

User Activity

Posted comments not seen once logged in to CSC

Points on Leader boards have decreased since migration

Viewing other peoples posts incorrectly states "You posted this Discussion"

ERSPAN on Catalyst 6500

Hi,

Hi,

Hi Sheldon,

Hi,

Hi