About Nizam Hafiz Md Ishak

Nizam Hafiz Md Ishak · 09-27-2012

Hi,I'm wondering if there's a way we can limit the number of calls between two subzones, zones or VCSs. The scenario as below:VCS-E (owncompany) << -----neighbor/traversal/DNS zone over internet------ >> VCS-E (partner)My intention is to limit only 5...

Nizam Hafiz Md Ishak · 06-07-2012

I have a setup as briefly describe below where our meeting control softkey (on the 7975 phone of our CTS) dissapears after 3-4 minutes into a multipoint call.CTS (1.9) -->> CUCM (8.6.1) -->> VCSC (x7.0) -->> TP Server (2.2)The meeting control softkey...

Nizam Hafiz Md Ishak · 03-22-2012

Hi all,This is my first post here and I've been looking through the support community for CUCM & CUCxN upgrade but can't find a definite best approach to do so.Upgrade from CUCM 5.0.4 to CUCM 8.6.2Unity Connection 5.0 to Unity Connection 8.6I'm getti...

Nizam Hafiz Md Ishak · 07-11-2013

Hi Peter,Unfortunately no solution for this. I've checked with our local Cisco support here as well but the feature just doesn't seems to exist. The best we can do is to limit the bandwidth but it still doesn't solve our problem totally.

Nizam Hafiz Md Ishak · 10-02-2012

I'm using Provisioning Extensions on X7.2, and TMS 13.2.1. and more or less have the same setup i.e:VCSE -- >> VCSC -- >> TMS -- >> ADVCSE subzones (treat as authenticated), VCSC traversal zone (check credential)TMS using normal AD importI've created...

Nizam Hafiz Md Ishak · 09-28-2012

Hi Martin,You're exactly spot on with what I'm trying to achieve here. However I don't see how to go about this and hoping there's a solution to this.

Nizam Hafiz Md Ishak · 09-27-2012

Hi Alok,MSE <> VCSC <> VCSE <> VCSE (partner)The subscribed bandwidth is 10Mbps between partner VCSE and my VCSE. But we only provide 5 travesal license for parter use on our VCS and only 5 MSE ports when they want to do multipoint calls.So the idea ...

Nizam Hafiz Md Ishak · 09-27-2012

Hi Alok,It works in a certain way but I have no control over their bandwidth so what happened was they call in at a lower bit rate to fit in more calls when they found out that we limit the bandwidth. This ended up using more of our MCU ports & trave...

Member Since	‎03-18-2011 07:11 AM
Date Last Visited	‎06-19-2019 12:44 AM
Posts	12

User Statistics

User Activity

Limiting number of calls between VCS zones/subzones?

Meeting Control softkey disappear

CUCM 5.0.4 to 8.6.2 / CUCxN 5.0 to 8.6 upgrade procedure

Limiting number of calls between VCS zones/subzones?

Active Directory Authentication for Jabber video

Re: Limiting number of calls between VCS zones/subzones?

Limiting number of calls between VCS zones/subzones?

Limiting number of calls between VCS zones/subzones?