If you have the output of show process cpu sorted at the tine of the issue, also check if there was ...

Can you provide more details about your network and how these ppl using it?Sent from Cisco Technical...

You are absolutely right, the counters are only incrementing if the packets hit the gateway, but whe...

Are these switches directly connected or there are some switches or L2 cloud between them? This issu...

I beleive you will need to use advance IP services image, this one that you are using doesn't suppor...

Since you reloaded the switch then there is no logs we can get from it, i believe you should try loa...

It can be done using this commandswitchport unicast unicast suppression levelAnd the same for multic...

If the same subnet is being used on another interface you will get a different messageAre you sure t...

Can you provide the complete output?is the traffic matching the class-default?

bjornarbfew comments here:- The policy-map on the second router it looks it is not configured correc...

Can you provide more details, configuration? Show commands as wellSent from Cisco Technical Support ...

Can you provide your config on both switches in addition to show io mroute and show ip igmp groups a...

Why do you want to do it in this why, why don't you configure point to pint connections instead of v...

in addition to :show ip bgp dampening dampened-pathsshow ip bgp dampening flap-statisticsshow ip bgp...