About Shaun Stokes

Shaun Stokes · 07-11-2013

We've been trying to setup QoS for traffic leaving VLAN1 on FE0 in order to shape or police this to a certain value while prioritising voice traffic.We can mark the packets (DSCP value) either as they arrive on the WAN FE4 or as they leave VLAN1, but...

Shaun Stokes · 05-04-2016

I've just found the answer here: https://supportforums.cisco.com/discussion/10981341/13-problems-spa525g "The $MPWD macro is restricted for the purpose of Extension Mobility only, and as described in administration documentation. It is not expandabl...

Shaun Stokes · 05-04-2016

Hi, We've been following this thread using a slightly different setup, everything works except the password $MPWD macro. We authenticate all phones using the same digest auth details and instead parse the username, password and MAC address using the...

Shaun Stokes · 06-30-2015

We've found a work around, creating specific NAT translations to an internal interface for the ports which need to be externally accessible on the Cisco, before we create the 1-1 NAT using a route-map resolves the issue.

Shaun Stokes · 06-30-2015

Hi, Was this ever resolved? We often have situations where route-maps are requires on 1-1 NAT translations to forward a range of specific ports to a certain local IP address. Please see below for an example of our configuration, IP addresses have bee...

Shaun Stokes · 06-18-2015

Unfortunately Dual Registration set to yes has no effect. The phone still only registers with one server and doesn't automatically fallback. Dual Registration might only be active when using an Alternative Proxy. Thanks for your input, we'll work aro...

Member Since	‎07-11-2013 03:50 AM
Date Last Visited	‎08-18-2017 04:03 AM
Posts	11

User Statistics

User Activity

Configuring QoS for traffic inside a VLAN on Cisco 881

I've just found the answer

Hi,

We've found a work around,

Hi, Was this ever resolved?

Unfortunately Dual