About K D

K D · 07-17-2015

Hi there,I have got few 8945 handsets not able to complete a call over the pstn(pri). On debugging, I found that I need the command"bearer-cap speech" on the voice port. I wanted to understand the implications on the applying this command on the int...

K D · 11-23-2014

Hi There,I just wanted to ask for best practice port config on BE6K servers.The BE6K(UCS) is only hosting CUCM server. The switch port is configured as ether-channels.Below is the config that I am planning to apply. I am just wondering whether we sho...

K D · 03-31-2014

Hi there,I am just wondering if the below scenario works, if the L2 Fibre Optic Wan link is down between the two DCs. Please refer to attached diagram.======================================================================The Fibre link is L2 link, me...

K D · 11-03-2013

Hi there,we have deployed a HA pair on 5508 controllers. I am just wondering if a failure happens oh the active box and HA unit takes over as active box, Is there any ways to send notification advising that standby box is now active.I know this can...

K D · 10-29-2013

Hi, I am hitting bug, where the nms service stops atleast twice in a week and and then come back after 10 mins.Does ny one know when there will be a patch release for this issue?

K D · 11-23-2014

Thanks Terry, I assume that this applies for CUCM running on UCS server as well?

K D · 08-18-2014

Thanks All for yout input. I have this APs deployed with spacing of about 4m. Works fine . no issues. Since the APs are close, the TPC is set automatically to 8 and RF footprint is all smaller, which works well for high density small rooms.

K D · 04-01-2014

Thanks Leo. we are planning to use 5508 across the DCs. The main reason for splitting the WLCs across the DCs is that if the L2 link fails, the APs in DC2 will still have access to WLC, if the Standby transitions to Active state. upon the link comin...

K D · 03-31-2014

The redundant ports are to be connected via the core switch(on same VLAN )at the respective DCs.So when the Fibre link between DCs fail, the RP also losses connectivity between WLCs.I hope I have answered your questions.

K D · 03-31-2014

no VSS or MEC, its only HRSP between them.

Member Since	‎05-08-2007 06:56 PM
Date Last Visited	‎10-19-2023 07:32 AM
Posts	28

User Statistics

User Activity

Bearer-cap speech command implementation

UCS-CUCM Swicthport configuration

WLC HA Failover on L2 Fibre Optic WAN

Monitoring HA Controllers

CSCuf25963 - PI1.2 Health Monitor is running, with an error/NMS Server is stopped

Thanks Terry, I assume that

Thanks All for yout input. I

Thanks Leo. we are planning

The redundant ports are to be

no VSS or MEC, its only HRSP