Our datacenter employs many Catalyst switches and so far we have used Cisco Network Assistant in order to manage them.Out latest addition has been 2x SG200-28 switches, however I can't get the SG's to work with latest CNA 6.2, even though they are su...
Symptom: Incoming call, one ring, dead air. Hang-up, call again, one ring, AA answers. This pattern repeats over and over.From term mon I see both calls answered. (Interface BRI0/1/0:2 is now connected to 398 N/A).Please advise.
I have a UC560 which generates tremendous traffic in our LAN. Switches go like crazy like they receive a huge load of broadcasts. When I disconnect it from the network all switches go back to normal operation. Is there any way to find out what genera...
Good day,I have a UC560 installation with the following two issues:1. Regarding the IVR, I have a random behaviour of no response described as follows: The incoming call is received (I see it in the terminal monitor) but the IVR does not respond. It ...
Hi to everyone,Could someone tell me please if the FAC - Feature Codes works for analog phones? When I try to use **4 or **5 the phone gives me busy tone.UC560 - SPA8000 I've connected analog phones to SPA8000 and registered them via CLI. This is my ...
Finally we've solved it!
The device's password included the character "#", which is not supported on CNA! After we removed the character off the password, it connected immediately :\
Anyway, thank you very much for your recommendations.
I hope this p...
Can I ask you which firmware version you are using on your SGs?
are you use some customized SSL certificate on switch?
No, I haven't configured anything related to the SSL certificate.
if so, could you try to use self-signed certificate gen...
I have tried this already, no luck... I found a post about the same issue about 1 year ago with SG300 and CNA, but was fixed with a firmware upgrade.That's weird, I already flashed the latest firmware (1.4.1.3 at this time) and I still get the error ...