Hi Sheldon, You might try creating a class map that matches on the XFF header. Then use that as the L7 load balance criteria (based on the hash value of the XFF header), using the predictor hash header. -Alex
Hi, Yes, it is possible to do this. Use the ACL filter for the source IP address under the policy-map type loadbalance. Then you would call that load balance policy in your multi-match policy under the appropriate class.for example:class-map type htt...
The CSS performs NAT by using source groups and either "add destination service" or "add service". For NAT on server initiated connections the "add service" is used. Do you have any source groups that have the services in question added to them?
Hi Anil, If both GSS appliances are part of the same cluster, they will share the same GSLB config. Thus they will both respond to DNS "A" queries that are received on their configured interfaces. So both GSS devices are active at all times and will ...
Hi,Here are a couple links to get you started:Product page:http://www.cisco.com/en/US/products/ps6906/index.htmlGetting started guide:http://www.cisco.com/en/US/docs/interfaces_modules/services_modules/ace/vA5_1_0/configuration/getting/started/guide...
