vinod.mali
Level 1
Level 1
Member since ‎03-15-2009
‎03-13-2024

User Statistics

  • 17 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Replies
Certifications

User Activity

Hi Guys,I am facing this issue of high memory util in one of my cat 3750 switch, when going through the show proc memory I could see the snmp engine holding  a lot of memory about 98 Mb.------------------ show version ------------------Cisco IOS Soft...
Hi Guys,I have arequirement where in I need to allow only specific vendor made desktops/laptops to be connected to the switch and block the rest.Say I want only the HP made Laptops to be connected on the Network. and block all other vendors. such as ...
         Hi Guys,I am facing high CPU util on my pix 515 E which is in failover mode.During peak hours the util is see rising to 60% where as in off peak hours it is normally12%.During normal operation the average utilisation was observed to be 30% b...
                 Hi guys,My peo module  WS-X4648-RJ45V+E i on 4506 is getting faulty i.e  the desktops are getting connected but the module is not able to deliver power to the ip phone.I tried and replaced the module  but it worked for  some time and...
GuysI am facing high cpu util  issue   80% in pix 515E with IOS 7.2(4).When a syslog is enable for informational/warnings level traps the util goes to 80% where as other wise it is observed to be 36-37%.When i changed the trap level to alert the util...
Community Statistics
Member Since ‎03-15-2009 07:07 AM
Date Last Visited ‎03-13-2024 12:10 AM
Posts 17