About EugeneL

EugeneL · 12-20-2020

When I am trying to configure a simple applet on the ISRG2 routers after entering the action for email, the variables end up being empty in the actual configHere is what I am entering in the config modeevent manager applet bgp_detectevent syslog patt...

EugeneL · 04-12-2016

I would like to have eem applet to run say hourly and copy file ( something like below ), I believe i may have an issue after action 1.0 as it results in the next line as it would confirm destination file name and i would assume expect the enter po...

EugeneL · 08-31-2015

Here is a sample scriptevent manager applet test event routing network X.X.X.X/X protocol BGP action 1.0 syslog msg "Route $_routing_network $_routing_protocol $_routing_type $_routing_lastinterface" action 2.0 mail server "$_email_server" to "$_emai...

EugeneL · 11-23-2010

Does any one know of a way to monitor changes in bgp routes received from remote routers. I am curios if theis could be done with EEM or something using just available technologies on the router ?Thanks in advance

EugeneL · 03-11-2021

Is there anything special that needs to be added in terms of NAT or similar ( same interface statements ) to allow the packet destined to the internet through tunnel . In my testing and packet tracer shows drop as a result.

EugeneL · 04-13-2016

Thanks Joe, How do i get by the confirmation prompt for copy copy flash:dhcp.db stby-flash:dhcp.db Destination filename [dhcp.db]? Copy in progress...C7181 bytes copied in 0.120 secs (59842 bytes/sec) I don't believe action 1.0 cli command "copy fla...

EugeneL · 02-01-2016

As was already mentioned you have to do upgrade to have the ability to turn that off. I know it works in 3.6.3

EugeneL · 09-03-2015

Thanks Joseph,I will give it a try and let you know

EugeneL · 11-23-2010

I was thinking more along the lines of "eem routing event" . If the routing table changes ... do somethingI don't really want to debug , I want this in place at all times , not just to figure out an issue.So monitor in thisinstance is monitior routin...

Member Since	‎06-11-2004 10:15 AM
Date Last Visited	‎04-23-2021 07:11 AM
Posts	11

User Statistics

User Activity

Issue with eem applet

EEM applet with timer

Question about simple script

Monitoring bgp route changes

Re: AnyConnect Split Tunneling (Local Lan Access, Split Tunneling, Static & Dynamic (domain)

Thanks Joe,

As was already mentioned you

Thanks Joseph,I will give it

Re: Monitoring bgp route changes