Hi Muhammad,I guess there is no "set ip next-hop recursive x.x.x.x" command supported till now on Nexus OS, If u are looking for loadbalancing, it can be achieved by " set ip next-hop1 next-hop2.....next-hop16 " CLI but it will not drop packet if the...
Hi Scott, You can use the monitor session session_number source command multiple times to configure multiple source ports. So on Switch B, configure.monitor session 2 source interface Gi0/2monitor session 2 source interface vlan 901monitor session 2 ...
Hi,I am sure you must have tried configuring command by keeping startup-config file at root dir. Adding reply just to notify possibility."boot config flash:startup-config'http://www.cisco.com/en/US/docs/ios/12_2/configfun/command/reference/frf007.ht...
Check output of 'show vdc membership' command. These interfaces will all appear
in VDC 0, which is reserved for unallocated interfaces:
vdc_id: 0 vdc_name: Unallocated interfaces:
Ethernet15/1 Ethernet15/2 Ethernet15/3
Ethernet15...