christopher_hall
Level 1
Level 1
Member since ‎08-01-2005
‎01-02-2018

User Statistics

  • 248 Posts
  • 0 Solutions
  • 55 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
1 Helpful Vote
50 Replies
20 Replies
10 Replies
5 Replies

User Activity

I have a ISR 4331. I've just upgraded the IOS to isr4300-universalk9.03.17.03.S.156-1.S3-std.SPA.bin. I've added a WIC card: vwic3-2mft-t1/e1. I'used the command: card type t1 0 1 and after a restart, the controller configuration was populated: contr...
Greetings, I have a Cisco ISR 4331 that I'm configuring to replace an older router. I'm adding a 2MFT-T1/E1 card into the first 'slot', which appears to be labeled NIM 1. Typically, I've added a card by typing......   card type t1 0 1   .....which, i...
Greetings, I have a 2911 router that I'm trying to configure SNMP on, but having problems with one command: snmp-server enable traps voice poor-qov. I'm thinking that maybe the command has changed or isn't supported, but haven't found anything specif...
We've purchased a 2911 router and a vwic3-2mft-t1/e1. I've inserted the card and configured card type, but my experience with these cards is that after adding a card, it should add serial interfaces. I'm obviously missing something. What I'm trying t...
We've recently added an additional T-1 at a site, which we'll bring up with the existing T-1 as a bonded T-1. Our router, 2811, only has one serial interface, so we're going to purchase a new router (it's also EOL). Looking at the 2911, it shows it h...
Community Statistics
Member Since ‎08-01-2005 05:38 AM
Date Last Visited ‎01-02-2018 10:13 PM
Posts 248
Helpful Votes Given To