About Ross Mccullough

Ross Mccullough · 07-05-2014

Group,I came across some unexpected behavior yesterday I was wondering if someone could help shed some light on the problem. In my DNS I created this record: _sip._upd.platautofinance.com which when I do a query using MX Toolbox it is correctly repor...

Ross Mccullough · 03-02-2014

Group,Wanted to get your input on an issue where I am sure I am overlooking something. I rebuilt the router for IP SLA and PBR but I am having a VPN issue. Here is the scenario:The LAN is 10.41.14.0/255.255.255.0On the LAN is a VPN device for the net...

Ross Mccullough · 02-13-2014

Group,Good morning, wanted to run some config questions by you as I am a bit unclear on a few things regarding load balancing and the IP SLA and PBR routing. Let's start with the basics:GigabitEthernet0/1 --> LANGigabitEthernet0/0 --> ISP 1 WANGigabi...

Ross Mccullough · 12-29-2013

Group,Have a small issue I am sure is related back to ACL. I wanted to have some experts take a look at my config please. Here is the issue:Attempting to create site to site between two offices but for some reason they cannot ping each other. It's a ...

Ross Mccullough · 12-26-2013

Group,Have some issues to run by you to get the experts opinion. Let's start with the setup:HQ2911 RouterSF300P Switches with QOS in basic mode, Voice VLAN 1SPA504 IP Phone(s)DC <-- Asterisk PBX located here with other SPA504 phonesWhats happening:So...

Ross Mccullough · 03-03-2014

Hello,It apprears to me that when I configured PBR on the inside interface that all traffic that should be routed to the vpn LAN address at 10.41.14.110 is actually being forced out of GigabitEthernet0/0. The PBR should have ACL 100 for the phones g...

Ross Mccullough · 01-04-2014

Karsten,Thanks again for your valuable input, the configuration is below. The endpoints are as follows:71.xx.160.123 --> 2911 IOS Router97.xx.231.22 -->SA540 SMB FirewallPlease let me know if you have any further questions that I can post up.<-- 29...

Ross Mccullough · 12-31-2013

Karsten,Thanks for your valuable insight, I can browse via http on our VPN connection now. Beautiful. Looking at my post do you have any insight into why the two firewalls wouldn't be able to ping one another? My item 1, is there anything in the ACL'...

Ross Mccullough · 07-10-2013

Rudy,Thanks for the follow up, appreciate the help. I took a look at the remote endpoint (an SA540) and it seems that all the settings as far as I can tell are the same on both devices. On the SA540 it just keeps showing timeout oh Phase 2 waiting fo...

Ross Mccullough · 06-28-2013

Abhishek,Good morning. After a week of hunting around I can report that the tunnels are still very buggy. I have found several things I would like to pass along for your input.I had an issue on the 2911 router with the clock source being off an hour,...

Member Since	‎08-09-2012 01:46 PM
Date Last Visited	‎10-09-2017 02:14 PM
Posts	27

User Statistics

User Activity

DNS SRV Proxy Lookup and Failover Mechanism / Unexpected Behavior

Static Routing Issue, Can't Ping VPN LAN Hosts IP SLA / IP PBR

IP SLA / PBR configuration questions / review please.

Need some ACL kung fu for Site To Site VPN issue ACL

Cisco 2911 QOS for VOIP - Unexpected Profile - NAT Issues - RTSP

Re: Static Routing Issue, Can't Ping VPN LAN Hosts IP SLA / IP P

Need some ACL kung fu for Site To Site VPN issue ACL

Need some ACL kung fu for Site To Site VPN issue ACL

Debugging Phase 1 Errors Site to Site VPN IPSec. Killing Me.

Re: Site to Site VPN Configuration Issue 2911 to SA540