Hi BoardI have problems getting an MP112 (Audiocodes) to register on a CUCM server. I have configured a user on the CUCM platfom, and a third party SIP device (Advanced). Assigned a new SIP security profile specifying that digest user should be used....

Hi CommunityWhat is the command to set both radios to run at 5 GHZ only. Our controller is an 5520 running 8.10.183.0. Most of the AP's is 9120, and they should be capable to run both radios on 5 GHZ.But I can't find the commands nesccsary to do this...

Hi Forum We have recently bought a few Cisco ISR1100 router with POE on the first 4 ports. They cannot feed the old 7960/7940 IP phones, but have no problems in feeding and Cisco 2802 AP. I suppose this has something to do with the non standard way t...

Hi Tech guysI have a customer with an WLC 5508 installation with Apple bonjour problems. Only one WLAN defined, all users and printers using the sam IP segment. All users are wireless, so are the printers. We are running 7.4.110 code on the controlle...

Hi ForumI have made a very simple test setup to check that a rogue DHCP is not allowed to pass out DHCP addresses to clients.I am using a linksys router, which acts as the rogue DHCP server. An IOS router connected to the uplink port acts as the trus...