Below is our scenario: PPPoE Server <---> G1-R1(ASR920)-G2 <------MPLS Core-------> G2-R2(ASR920)-G1 <----> PPPoE Client We configured xConnect between G1 of R1 to G1 of R2 and session was up. 1. If we configuration IP based connection by assigning I...
Does Cisco ASR 920 support PPPoE server on either BDI or Phy interface?
I tried to find refer DOC but no able to find where specifically mention support or not support.
I can configure and client can connect but routing was not working. I also can ...
Hi,
It look like L2 protocols like STP, CDP,.. is by default transported across bridge domain from one AC to other ACs.
How is to disable this behavior on bridge-domain or AC ?
Regards,
Hi,
I am using VPLS with manual provisioning. I am expecting there is L2 looping within the bridge domain. but i can not find the way to detect it.
In normal Catalyst or ME switch, i reply on "MAC address flapping" log to detect with VLAN is looping...
Hello, it is working now. the problem is one of the core interface has problem. by changing it to new interface, PPPoE is working normal. Thanks for reply.
-##the version that I am using does not support those config anymore. Ihave to use flow monitor command. So there is no option to netflow versionbeside ipfix, v9 or v5.
There is no option to select version 8.Available options are: ipfix IPFIX (Version 10) netflow-v5 NetFlow Version 5 netflow-v9 NetFlow Version 9any suggestion ?
I am trying to enable PPPoE server on my router, ASR920. it can be Physical or BDI Interface.
As you mentioned, BDI does not support as PPPoE Server interface.
How about Physical interface ? like G0/0/0 or G0/0/1 ?
Hi ,
[1]
I am matching traffic as below:
!
interface Bundle-Ether8.1 l2transport
encapsulation dot1q 202-204 , 207 , 209-215 , 217-226 , 228 , 230-242 , 247-251 , 253-255 , 258-270!
I am facing a problem where i can not use "Comma" more then 8 times...
