Hi EveryoneI will have to configure SRST on Cisco 3945 for our remote site.This ISR will also act as remote-site’s main router and also will have some Analogue phones.Our main site has Call Manager 8.6.2.I’m planning to configure H323 Gateway with SC...
We are using CUCM 8.6.2:User-A, with extension ‘xxxxx’ calling internal switchboard operator ‘yyyyy’ (switchboard operator using ARC operator console system) with the request to connect to doctor’s mobile number ‘zzzzzzzzzz’;Once the switchboard oper...
Hi EveryoneI’ve got this new Cisco IP phone 8945 and wanted to install the latest firmware (cmterm-894x-sccp.9-2-3-5.cop.sgn), to be able to use the new phone on our corporate CUCM 7.1.5.I’ve restarted TFTP services on both Publisher and Subscriber a...
I ended up logging a call with Cisco and got the solution, so thought I'll share with you all.Although there is possible configuration per DN but that can be a bit of complex configuration and also will vary depend upon individual route pattern and c...
Hi nikshahThanks for your respond and detail steps.I'll have to read a bit more about the impact of rebooting the cluster first before proceeding.Thanks to everyone.Regards,Mohi
Hi JavaSorry for the delay, I was off sick.I would like to clarify one thing though; if I install the device pack you mentioned above can it create any problem to the live system?This IP telephony system is running on CUCM 7.1.5 and around 1500 phone...
Hi Java Thanks for your respond.Could you please point me to the link for Device enabler or device pack for cisco 8945 ip phone?If this will be the Zip file version of SCCP firmware then I got it and other than SIP version there is another link under...
