About support aciernet

support aciernet · 10-05-2017

Hi all, ASR9K is supporting VxLAN with MP-BGP/EVPN, it it not very clear to me if it supports Q-in-VNI and if yes, what would be the features and limitations here ? The docs on the website are not very clear about the subject .. Thanks

support aciernet · 03-26-2014

I followed the IAC (IAC 4, PSC 10) install guide, but I'm stuck at the "Setting REX Agent Configuration".I should wait for the task to complete, but the state is blocked at "Ongoing (2 of 3 Completed)" since yesterday. I don't know why it's stuck an...

support aciernet · 09-17-2013

Hello,did anyone encounter the error I wrote in the title?I went to http://<Ciaca server>:8080/RequestCenter/businessengine/configdebug.jsp to check the business engine config, every thing seems fine.I'm going to use a clone/Backup of the VM where CI...

support aciernet · 08-07-2013

Hello,At Aciernet, we've been using MCAK for a couple of months, creating Amazon VM's which always had private ip's, and recently we've been thinking of cerating machine with public addresses so people could connect to them without creating a VPN. Un...

support aciernet · 07-02-2013

Hello everyone,At the moment I am using MCAK 3.1.1, I've installed the v5, as well as CPO hotfix 10,11 and 14.Here are the main issues I've had until now, that have not been reported on the forum:- In the service "Create POD", I couldnt submit the fo...

support aciernet · 03-28-2014

I do have clicked again and again on the requisition number, but with no success, as I said in the post above, reloading the VM do the job, don't know why.For other folks, it takes around 5 min to complete.Again, thanks for your help.

support aciernet · 03-28-2014

After cancelling the request, then reloading the service link (stop and start), and then reloading the VM the request was successfull. Thanks for the help

support aciernet · 03-28-2014

Hi,Thanks for your reply. I already try the REX login, and validate that the REX service was "up". I also try to cancel the requisition and make a new one with no result.As you suggested I've updated the request (not sure it was what you mean by "res...

support aciernet · 01-09-2014

Run into the exact same problem, don't trust the log, the problem came from the asa unable to reach the pnsc.Cend.

support aciernet · 08-02-2013

I've been able to remove the admin role from a site administrator with an OTA.I know there are issues when you log with an user then logout and relog with another user, CIAC considers that you are still the previous user (I've encountered the issue s...

Member Since	‎01-20-2012 06:01 AM
Date Last Visited	‎02-28-2023 02:50 AM
Posts	30

User Statistics

User Activity

ASR9K support for Q-in-VNI

PSC Setup - Setting REX Agent Configuration, state blocked at "Ongoing"

Business Engine Requisition Queue is not available

Creating an Amazon VM with a public ip address

Issues I've stepped upon while testing MCAK 3.1.1 v5

I do have clicked again and

After cancelling the request,

Hi,Thanks for your reply. I

pNSC asa1000v fail to register

Re: Org Tech Admin can add user from other org?