Hans Juergen Guenter
Member since ‎09-17-2012

User Statistics

  • 97 Posts
  • 2 Solutions
  • 36 Helpful votes Given
  • 1 Helpful votes Received
Recent Badges
1 Helpful Vote
50 Replies
1 Accepted Solution
20 Replies
10 Replies
5 Replies

User Activity

Hello,I currently have the following problem. In my test environmentI was able to successfully test the following AP. However, nowat the customer, this AP cannot connect to the WLC.It is an AIR-CAP1532E-E-K9. The other APs are AIR-AP3802I-E-K9.Can so...
Hello,I have the following problem, if I have to disconnect the WLC 2505 from thepower supply, it loses the time. It is then always on 01/01/2000, even thoughan NTP server is entered.Is there a way to check that the NTP server that is entered on the ...
Hello,I'm slowly getting a little better at configuring the Cisco AP via the WLC. Now I'm in theprocess of setting up a guest WLAN in addition to the internal WLAN. Now my questionabout it:1. How do I configure the switch port where the AP is connect...
Hello,I currently have the following problem. I'm in the process of setting up a testenvironment and somehow the switch doesn't load the GUI even though I'veactivated http and https in the config.Do I have to do anything else so that it can load corr...
Hello,I have the problem with a switch that it does not allow me access via theweb interface. It says the following when logging in via the web interface:Wrong credentials. Please login again.But I have created a user via the cli and this also has ad...
Community Statistics
Member Since ‎09-17-2012 11:27 PM
Date Last Visited ‎05-15-2023 04:14 AM
Posts 97
Total Helpful Votes Received 1
Helpful Votes From