Hans Juergen Guenter
Level 1
Level 1
Member since ‎09-17-2012
‎03-15-2024

User Statistics

  • 107 Posts
  • 2 Solutions
  • 36 Helpful votes Given
  • 2 Helpful votes Received
Recent Badges
1 Helpful Vote
50 Replies
1 Accepted Solution
20 Replies
10 Replies
5 Replies

User Activity

Hi,I have a question about Identify a Client by name on the WLC. It is currently the case thatI only see the MAC address of the clients or under the name that it was not identified.What do I have to configure now so that I can also see the name of th...
Hello,I have a question or two about setting up a site-to-site VPN between a Meriaki MX67 and a Sophos XGS.So I have already found the point on the Meriaki Cloud page where I can activate the site-to-site VPN. However, there is no button there to man...
Hello,I currently have the following problem. In my test environmentI was able to successfully test the following AP. However, nowat the customer, this AP cannot connect to the WLC.It is an AIR-CAP1532E-E-K9. The other APs are AIR-AP3802I-E-K9.Can so...
Hello,I have the following problem, if I have to disconnect the WLC 2505 from thepower supply, it loses the time. It is then always on 01/01/2000, even thoughan NTP server is entered.Is there a way to check that the NTP server that is entered on the ...
Hello,I'm slowly getting a little better at configuring the Cisco AP via the WLC. Now I'm in theprocess of setting up a guest WLAN in addition to the internal WLAN. Now my questionabout it:1. How do I configure the switch port where the AP is connect...
Community Statistics
Member Since ‎09-17-2012 11:27 PM
Date Last Visited ‎03-15-2024 12:01 AM
Posts 107
Total Helpful Votes Received 2
Helpful Votes From