Andy White

I will just use the management port then as that works fine.

Isn't that the same discussion as this one that you replied to?

Ah so maybe that is it? I was trying to connect to the service port with option 43, but it is unrout...

On my router (acting as a DNS server) I changed: ip host CISCO-CAPWAP-CONTROLLER 192.168.0.110 (Serv...

On the router I added: Router(config)#ip dns server Router(config)#ip host CISCO-CAPWAP-CONTROLLER 1...

Sure: APs have been used on the controller before (Cisco 3702i's) Hex f104c0a8006e = the service por...

Hello, I have a Cisco 1941 with some DHCP scopes on it and I need to add option 43 to them so they c...

Thanks. So what should be the steps? At the moment I will have to manually fail over to the backup l...

Hmm sounds a bit scary. The other option is to get a second router on the same public IP range from ...

Thanks - I was just hoping to call one of the new sub interfaces the same (outside) so little would ...

Hello, With Regards to the "nameif" on the sub-interfaces would I name the main line something like ...

Hello, We have 2 ASA 5520 firewalls working in active passive, below is the config for the outside i...

Hello, I noticed that we had a AP that was down yesterday and I'm not sure how long it was down for....

Already tried that and it didn't work. I guess it's a physical visit or I create the VLAN again?

Hello, We have an old site with about half a dozen switches (2960s, 3750s), and they they have an ac...