Hello to all ,I have CUCM 8.6.2.22900-9 and 3 Cisco 8941 in 3 different sites . In the 3 sites the Route Group depends of a router with PVDM3 ( video capabilities ) , Cisco 3925 in 2 cases and Cisco 2921 in the other .The question is : when i Try to ...
Hello to all I have a router Cisco 2821 and 4 analog lines in FXO ports , when i place a call from outside i heard the IVR but the hunt of phones not rings , here is the sh voice call statRouter#sh voice call statCallID CID ccVdb Port ...
Hello to all , I have CUCM 8.6.2.22900-9 and a particular case : A Cisco 8961 is not registered , the message in the CUCM is rejected , and in the phone{s display is Phone not registered .I have test in a lot of ways ( shut and no sht of the sw port ...
Hello to all , i have CUCM 8.6.2 and in a building the conference failsWhen a person add 2 more , after five minutes the conference is down Can you give me some advice ?Thanks a lot !Hugo
Hello to all ,.I have some routers Cisco 2921 , with FXO ports and analog phones connected to it , the problem ( in 3 sites ) is about the calls , there are down after 2 minutes The version ( in 3 routers ) is Cisco IOS Software, C2900 Software ...
Jorge , sorry for the delay Finally the problem was some voice ports of SRST, the dial peer match them.When I shutdown this ports the call can be completed !!!Thanks a lot !!
Chris :The phone is defined in CUCM .The messages are :VPN not configuratedVPN error MAC.cnf.xml.cgn ( http )Trusted list updatedupdating trusted listand a loop of this ..........How can I delete the certs of the phone ??many thanks Hugo
