Hi,Please, I need your support and help to be able to view and play the RTSP stream out from the Cis...

Dear All, what is the input/output throughput of Cisco VMS"Video Management server" ? ThanksOmar Mah...

Hi Michael,this issue happens every time i booted the serevr.i didn't upgrade the server since i ins...

Hi,I have a Tanbderg content server V.4, enter the idle mode suddenly, and so this server couldn't b...

Hi All,I have Case: .... please see the diagram in the image below1- ASA Firewall version 8.2.2- Acc...

Hi Cristian,Thanks For your Co-Operation..I already did this, and the problem comes when a second so...

Dear All, Please, advise me how to solve the following issue that I am Facing with 6000MXP Profile U...

Dear All, Please, advice me how to solve this issue that I am Facing with 6000MXP Profile Unit, and ...

Dear All,Can I use the Cisco Tandberg ISDN Link with C40 V.C unit using EtherNet Switch in between a...

Dear All,I have a Tandberg C60 Unit in the inside network and I did static NAT on firewall but I hav...

Dear All,I have a Tandberg C60 Unit in the inside network and I did static NAT on firewall but I hav...

Hi Harish, I did what you say, but the problem now, I cannot be reached from the outside "could be c...

Dear All,I have a VC system "Tandberg C60 Model", and ASA firewall. C60 unit is in the inside zone o...

Dear All,i have a VC system "Tandbger C60 Model", and ASA firewall. C60 unit is in the inside zone o...

Dear All,I have the following topology:ASA Config as following:MyASA(config)# sh run: Saved:ASA Vers...