Wondering what's the CLI to verify AP LAN interface speed on Cisco 9800 controllers... On the AireOS controllers, you can do 'show ap stats ethernet summary'... And this command is not available on 9800 WLC.
Hello,
For deployment of twenty 3702 AP with one WLC 5508, in order to avoid the 5508 become the choke point, do you think using Flexconnect in staed of Local mode will help?
Thanks!
Hi there,I have a client is using Cisco PI 1.3 with LifeCycle licensing and trying to manage Cisco switches and routers in the network. The client is able to add switches to PI and get the CPU memory utilization sort of status, but that's all. What t...
Hi there,My questions is can a 4 port PoE switch module (EHWIC-4ESG-P) and a 8 port switch module (EHWIC-D-8ESG) be used at the same time in a Cisco 1941 router?Thanks in advanced.Robin
Hi all,I am running into an issue with disabling the web-auth secure web on an 5508 anchor WLC running 7.2.110. After the WLC rebooted, the guest authentication portal didn't show up...I could see the IE tab showed Web Auth Redirect though...Changed ...
Thanks for the reply. The commend you refer doesn't return any output, maybe it's for AP with specific ehternet config? Actually, found the 'show ap name [ap-name] ethernet statistics' can show the ethernet speed. However, this commend only shows 1 A...
Thanks Tim for your reply.
I should have asked the question more clearly.
Understand that Flexconnect is design for remote locations that no need to have a WLC onsite, and use Local switching for wireless traffic to mitigate the slowness of the WAN ...
The custome page might be from Cisco web auth page sample by the look of the webpage. I don't know how to verify whether or not it was hard coded for HTTPS...Do I also need to diable the web-auth secure web on the main controller? This anchor is run...