About hallvard.solem

hallvard.solem · 06-26-2012

Hello.I have a ongoing project configuring a cisco wlan with 802.1x, where microsoft network policy server is used for radius authentication.Configuring the SSID on the WLC, and the 802.1x on wlc/radius server works fine, users type in their username...

hallvard.solem · 09-13-2011

Hi,we have a new IBM Bladechassie with two Cisco nexus 4001i switches.I have configured one external port on each nexus and connected them to a cisco 6509 with 1G cisco SFP-modules and MM fibre.Both the nexus and 6509 ports are configured as trunk po...

hallvard.solem · 07-15-2011

Hello!We have some locations in our WAN with cisco 1712 routers that we want to replace.I have now bought a cisco 1921 router for test, to see if this can replace the old routers.While testing the 1921 I have ran into some problems which I hope someo...

hallvard.solem · 03-10-2014

I think you should take a look at the recommended bandwidth through the appliance in this forum post:https://supportforums.cisco.com/discussion/12101786/ironport-s660-capacityI am pretty sure your S670 is overloaded.

hallvard.solem · 11-21-2012

Hi,I tried the exact same thing as you, handheld devices with NPS authentication.Unfortunately the cisco ad agent supports only kerberos authenticated devices, not radius. And this is not possible.

hallvard.solem · 06-27-2012

Thank you for replying Jatin,After enabling accounting, I can now see the client ip-address in the nps logfile.However cisco active directory client cannot map the ip against username unless it's in the windows security event log. Im also afraid it h...

hallvard.solem · 11-01-2011

Solution: the port on 6509 had to have the following configuration:bandwidth 1000speed nonegotiate

hallvard.solem · 09-13-2011

Yes, the module comes up, we are using sup-720.I have a lot of other switches connected to the module, and I've also tested this port against another switch and it works fine.sh mod:XX#sh modMod Ports Card Type Model ...

Member Since	‎03-02-2010 04:23 AM
Date Last Visited	‎04-09-2018 06:45 AM
Posts	29
Total Helpful Votes Received	15

User Statistics

User Activity

802.1x WLAN auth not showing client ip in win 2008 AD security log

Nexus 4000 won't connect to 6509

Cisco 1921 router - Trunk and vlan interface

I think you should take a

Iron Port Transparent Authentication of Mobile Devices

802.1x WLAN auth not showing client ip in win 2008 AD security l

Nexus 4000 won't connect to 6509

Nexus 4000 won't connect to 6509