About Shawn Purdy

Shawn Purdy · 07-26-2016

Good afternoon all, We've noticed a problem with a latest shipment of Cisco AP's. They've come preloaded with code version 8.2.x. However our standard is still 8.0.120 with plans to go to 8.0.135 to support the revision -B domain AP's. However th...

Shawn Purdy · 06-27-2016

Is there a way to monitor anchor mobility tunnels? We have 3 corporate locations currently separated by a FW. The anchor mobility tunnels periodically go down and we only hear about it when a user indicates they cannot get on the wireless network. ...

Shawn Purdy · 04-18-2016

Has anyone had experience with "Leaky Coax" via wifi. I have an industrial site that has difficulty with adding AP's due to the concrete and steel infrastructure. Someone throughout the idea of using this type of cable. From what I've read its not...

Shawn Purdy · 08-13-2015

Good day all got a troubleshooting question here I need to ask.I have received complaints from user connections dropping when using smart phones such as Apple and Android. The current AP they are using is an 1131 (to be replaced soon) however when I...

Shawn Purdy · 07-08-2015

Over the past few years I have deployed a couple of Cisco 7510 controllers. All of them use Central switching. None of my small offices have local resources (file/print servers, etc..) so i tunnel all traffic back through the wan via the central sw...

Shawn Purdy · 06-27-2016

Thanks, Can these entities be exported to an outside system? Via some type of SNMP trap?

Shawn Purdy · 04-18-2016

It does. The use would not be low bandwidth. This area could potentially have voice along with data applications leveraging it. which is why i was concerned about this being a viable option. Thanks for the info.

Shawn Purdy · 08-13-2015

I was thinking the same thing. It is a pretty old AP. I will replacing it within the next couple of weeks but I wanted to rule out any outside interferes.

Shawn Purdy · 08-03-2015

THanks that did it. I'm using 7.4.110. I was typing in the name wrong. I used an AP with a shorter name and that worked.

Shawn Purdy · 08-03-2015

Can someone confirm the syntax of the command for checking the AP;s? When I do a "show AP inventory all" I get Cisco AP name is invalid. The syntax I am told to use is the following. show ap inventory <Cisco AP>not sure what name to use. I've the...

Member Since	‎10-03-2011 01:13 PM
Date Last Visited	‎06-30-2023 09:59 AM
Posts	52
Total Helpful Votes Received	16

User Statistics

User Activity

Downgrading an access point from 8.2 to 8.0.120

Monitoring Mobility Tunnels

Leaky Coax for Wifi?

Can in ceiling air conditioners cause interference?

FlexConnect Local Switch vs Central Switching

Thanks,

It does. The use would not

I was thinking the same thing

THanks that did it. I'm

Can someone confirm the