About Anthony W.

Anthony W. · 08-22-2013

All,I have a basic EZ VPN and my outside interface has a standard ACL firewall. I can VPN into the system just fine and have access to all internal items but I have no internet access. The router log shows:003253: Aug 22 15:22:26.456 MDT: %SEC-6-IP...

Anthony W. · 06-14-2010

Hello,I have no idea why my Cisco EZVPN is not working. I have used a very similar config before and it worked just fine. I am using a Cisco 1751V running c1700-adventerprisek9-mz.124-25c IOS. I have tried just about every combo if crypto and hash...

Anthony W. · 03-31-2010

I think I already know the answer for this but I just wanted to make sure. We have 4 7985 phones and we are able to make point to point video calls but once we conference the video goes away and we only have audio. I know the VT Advantage software ...

Anthony W. · 02-09-2010

First off, thanks in advance for helping out on this. I know it should be easy but for some reason I cant figure it out. I have set up a test CCME and everything is working just fine. I have 2 phones and they are registered and all is well. What I...

Anthony W. · 02-26-2008

Hello,I am running a 10 digit dial plan in a CallManger 4.1 environment, but each site is only dials 4 digits internally. This is working just fine. The issue I have is when I drop into SRST mode; the phones register as full 10 digit numbers to the...

Anthony W. · 03-26-2021

Personally I would try adding this at the end of the ACL: 999 deny ip any any log This way you will see in the log what is actually hitting the implicit deny on the ACL to ensure that you are really having a ACL issue. If not, you may want to look at...

Anthony W. · 03-26-2021

I would have to look at the full config but if you did not have the bindings set on the dial-peer, CUBE will look at the voice service voip section next. If nothing is set anywhere, CUBE tries to find the right interface (I would have to look up the ...

Anthony W. · 03-16-2021

Looking at your traces: Incoming Dial-peer=1Outgoing Dial-peer=11 Can you please post the config for those 2 dial-peers? Also what is the MRGL on each trunk and does it contain a MTP? If a MTP is trying to be invoked, your having a DTMF mismatch and ...

Anthony W. · 01-11-2019

This worked! We had a multi-domain setup and could not use UPN due to O365 using the UPN attribute. By setting LDAP sync to mail and then setting up the LDAP directory’s, that enabled LDAP sync. Authentication we were trying what we thought was th...

Anthony W. · 12-06-2017

Good post. I ran into the same issue. Could not restore a 10.0.1.11900-2 CUCM Pub on new hardware. DRS kept timing out and giving the error. By keeping only the Pub files and the drfComponent file in the SFTP folder, that allowed me to move forwa...

Member Since	‎02-26-2008 10:54 AM
Date Last Visited	‎12-14-2022 01:41 AM
Posts	35
Total Helpful Votes Received	61

User Statistics

User Activity

VPN Web Access with ACL Firewall

EZVPN Error

Video Conferencing in CUCM 6.1

CCME Internal Dialing Question

SRST Translation Question

Re: no one way audio

Re: No audio when call goes to the call handler

Re: No audio when call goes to the call handler

It Works!

Re: Disaster Recovery Problem