How do you show the controllers configured on an AP? When I read through the docs it say to use the show capwap ip config. Verify You can use the show capwap ip config command in enable mode to view the CAPWAP configuration present on the LAP. Here is an example: AP1240#show capwap ip config
LWAPP Static IP Configuration
IP Address 10.77.244.199
IP netmask 255.255.255.224
Default Gateway 10.77.244.220
Primary Controller 172.16.1.50 http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a00808e2d27.shtml When I run it I get no output. I am guessing because the AP is DHCP 3602-E#sh capwap ip config LWAPP Static IP Configuration I am not having any luck finding this data anywhere else. 3602-E#more flash:private-config %Error opening flash:private-config (Permission denied) thanks CCNP - Wireless CWNA and CWAP
... View more
So I setup ssl vpn and it works good. I can connect to network and hairpin back out to the internet. I can also hit my ESXi server and http services on boxes on the inside network. I can't get to windows file shares though. Is there something I need to enable to get this this work? My searches have turned up results on clientless ssl connections. I have the client install though. thanks CCNP - Wireless CWNA and CWAP
... View more
Amjad, yes I understand that but you need understand the scope here. It is beyond what this guy is going to care about. CCNP - Wireless CWNA and CWAP
... View more
Move the modem in to your room. draw a layout of of your house and where the stuff is located. Do you have a cable port anywhere close to the center of your house? Does wireless work on anything else? Download the home version on your laptop http://www.metageek.net/support/downloads/ You'll want -70 or lower (-60). If you get in to the high 70's or 80's you'll pr CCNP - Wireless CWNA and CWAP
... View more
From show controller d1 Configured TxPower: -4 dBm Allowed Power Levels: -4 dBm Allowed Client Power Levels: -4 dBm Active Rates: CCNP - Wireless CWNA and CWAP
... View more
Anyone ever seen this problem? not working 3600e(config-if)#power local ? <2 - 2> One of: 2 maximum Set power to allowed maximum Instead of working 3600e(config-if)#power local ? <2 - 23> One of: 23 20 17 14 11 8 5 2 maximum Set power to allowed maximum CCNP - Wireless CWNA and CWAP
... View more