hiI have some IP phone registered to cucm, there is a phone display a fork nearby the Directory number , but the phone registered to cucm is OK, and call is good.
I have already configed all ap with primary & secondary controller address per ap parameters, I want to remove the paramters quickly ,I found the command : config ap secondary-base controller_name cisco_ap [controller_ip_address] , that can added in...
I have the cucm 9.0 I install and configed cucm pub sub ok, the ip phone can register to pub,but when I change the phone to register that sub,then can't registerafter I googled some document,I checked the following 1. Network connectivity between the...
I have a mcs7825-i5 with unityconnection version 8.5, then I want to upgrade to 8.6, but in the upgrade procedure the status reported that "error encountered:this hardware is not longer supported " But I checked the url http://www.cisco.com/en/US/...
I have an 2911 router used for voice gateway,it has one e1 port and one PVDM3-16, and when I config e1 timeslots 1 to 31 ,it's reported no dsp resources,router(config)#controller e1 0/0/0 router(config-controller)# pri-group timeslots 1-31% Not enou...
Hello,Thanks for your reply, but the customer has replaced anothe phone, it's ok , and he has not test to change that 3 label text.In the future, if he test that I will update here.
Hi I have enabled the name information on the Dn, there are the 3 field: Display (Caller ID), ASCII Display (Caller ID), Line Text Label the content is Xiaoxia.Jia on the other normal phone,the first line on the phone is only display DN number, witho...
