About Stephane Gilliers

Stephane Gilliers · 12-03-2013

Hello,I have 9951 phones and I would like know how can I do for have some buttons :- Button Pickup or Pickup Group- Button Call ForwardI search in CCA "Phone Template" but there are no phone template for 9951 phones.Thank you.

Stephane Gilliers · 12-02-2013

Hello,I have a Cisco UC540 with 10 SPA504G.Now I have 4 CP-9951.I have the software pack in french and all my 504G are in French.When I boot and configure the phone, he is in english.I search in settings into the phone but nothing view.Do you know ho...

Stephane Gilliers · 07-11-2013

Hello,I have a customers which have two Cisco UC560/540.The both site are link with VPN IPSec (not with Cisco UC).They can see together with private IP.The Voice subnet are the same (10.1.1.0).How can I do for link both system and than user can dial ...

Stephane Gilliers · 06-05-2013

Hello,I post here because I search many hours for a stupid problem.I have a Cisco UCS C22 M3 with soft RAID LSI MagicRAID.I have two hard drive of 1To.I create a RAID Array with type 1 (mirror).When I launch VMware ESXi 5.1 U1 install I see not the R...

Stephane Gilliers · 05-28-2013

Hello,With Console cable I can see correctly the debug log.Example : debug tftp eventsWith SSH this command don't working (or the log working but no see in ssh window).How can I do for see debug log in SSH ?Thank you very much,Stephane.

Stephane Gilliers · 08-28-2015

Hello Eric,The case number are 636201115.Very nice, the person take the time for good explain.It seems provide for channel cannal 2.4Ghz who are very used.We active also the 5Ghz 20Mhz radio even if I'm in simple PoE. I see in times if it's better. R...

Stephane Gilliers · 08-24-2015

Hello Eric,I'm come back to office.I think I open a case because I receive always email (the mac address change in mails) : Log Message from AP 10.10.92.7 TIME Priority Process Id Message ===============================...

Stephane Gilliers · 08-07-2015

Thanks. WPA-TKIP are already disabled but MFP was on "Capable".I configure it in "Not Required". Also before I see on another topic and configure 86400 for Broadcast Key Refresh and disable TSPEC mode. thank you.

Stephane Gilliers · 08-07-2015

Hello Eric,You're right, I don't post a message.(I don't know if I have a support contract for this little WAP). Praticly all my PC lost wifi periodicly and sometime they must wait 1 or 10 minutes for have network again. Each time I receive this emai...

Stephane Gilliers · 08-07-2015

No it's always disaster.And I disable 5GHz because I'm in PoE. I'm very surprise than Cisco do nothing.

Member Since	‎04-09-2013 04:43 PM
Date Last Visited	‎05-29-2019 12:06 AM
Posts	35

User Statistics

User Activity

UC540 - 9951 How can I configure action/button

UC540 - CP-9951 How to configure with French Language

Trunk SIP between two UC560/540

UCS C22 M3 Software RAID LSI Problem with hard-drive

See debug log in SSH

Hello Eric,The case number

Hello Eric,I'm come back to

Thanks. WPA-TKIP are already

Hello Eric,You're right, I

No it's always disaster.And I