About vatandeep singh

vatandeep singh · 05-03-2013

Hi All,There is an issue with the FXO port. Users are not able to make the outgoing calls from FXO numbers.when they try to make the outing calls they listen blank and after 6 to 10 sec. Call got automatically disconnected.I have taken the debug for ...

vatandeep singh · 08-15-2012

After the fresh installation of cisco ICM AW, distributor cmsnode is fluctuating. what to change is there any domain related issue or anything else?????

vatandeep singh · 10-16-2014

Hi Jaime, is there any setting on the call manager if phone is off hook and it wait for 5th digits if dial plan is over lapping.e.g. I have two numbers 4701 and 47010 , so if some one wanna dial 47010 on off hook and it shouls not dial immidiatly by ...

vatandeep singh · 03-04-2014

Hi all,still are we having that limitation of Cisco to get ring tone while same line is busy with another call or any solution is implemented in new versions of CUCM ????Thanks and regards,Vatandeep singh

vatandeep singh · 01-05-2014

try to check whether IP phone is accesible from your Call manager to that port, have you checked it by changing the port.

vatandeep singh · 07-29-2013

Hi Mohammed,Can you please share all voice-port sh run.Thanks!!!Vatandeep Singh

vatandeep singh · 07-23-2013

Hi Merkin,Before changing the NTP make sure you are using your CUCM on MCS server or lower platfom.Changing the NTP server on UCS causes change in licence MAC of CUCM.ThanksVatandeep SinghKindly rate if content is helpful.

Member Since	‎08-12-2012 03:33 AM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	16
Total Helpful Votes Received	4

User Statistics

User Activity

Outgoing calls are not going through FXO ,But no issue with incoming calls

After the fresh installation of cisco ICM AW, distributor cmsnode is fluctuating.

Hi Jaime, is there any

Busy or Any tone different than ring tone when first line is bus

Re: 9971 phone not registered

FXO port issue

NTP error