FRANCISCO IBARRA

I modify the ACL, but I still have echoed by the ASA to the customer PC.Check the statistics of inco...

Change my pool with address range 192.168.100.x.Also active crypto isakmp nat-traversalbut does not ...

As for routing'm using only one static route. and in the use of nat I am using it as seen in the Int...

hiIf the VPN Client is running on Windows Vista. And he added as the securated route 0.0.0.0 0.0.0.0...

First thanks to answer:here's the log of the connection. I saw that was a failure to add the route i...

My topology is as followsI have a Cisco 1841 that does not manage, because it belongs to my ISP. In ...

hi,The computer where I run vpn client is at first a 192.168.1.x ip when I make the connection the n...

Hi,I tested with the command sh run sysopt all I get the following output:sysopt connection permit-v...

Could you tell me the steps to do what you suggest, Thanks.On the client if I that increases the enc...

Well if the client sends packets but not receive packets. I'm not using split tunnel. I think I miss...

I make a connection through Cisco VPN Client and ASA 5510. Yet I can not see the computers that are ...