Hi, Just a little confused here..... I can do the exact commands in the EEM script directly and it does what I need it to do. However, the script, when triggered, with the "EXACT" same commands sometimes works / sometimes not. Arrrgghhh! So, ...
Hi, I am struggling / looking for a solution to have 2 different subnets on different frequency bands. For example: Is there a way to assign a subnet to the 2.4 band and a different subnet to the 5.0 band? Maybe someone can give me an example...
Hi, I am struggling to find a solution to do the following: Permanently block an ip after X amount of login failures? I know it sounds simple, but, maybe someone can give me an example. I don't want to block a range of ip's, just a specific o...
Hi, I am struggling to find a solution to do the following: Permanently block an ip after X amount of login failures? I know it sounds simple, but, maybe someone can give me an example. I don't want to block a range of ip's, just a specific o...
Hi, I have been struggling to find/create an EEM script solution to this problem. Basically, we are using a 3825 router to connect to a 3rd party VPN service. The tunnel will go down once in a while. I have yet to find a solution to maybe do ...
Hi, I thought of another possibility....What about using different SSID's assigned to different subnets / VLAN's regardless of the frequency band? Jason
Hi, Here is my working solution that I have used for years with StrongVPN.http://forum.strongvpn.com/forums/topic/3480/cisco-ios-l2tp-working-connection-config Hope this helps. Cheers. Jason
Hi, Thanks for the great post. I obviously modified it a bit to do a shut/no shut on the WAN interface and the Virtual-PPP interface and gave it a timeout of 5 minutes. I looked into doing a vpdn flush, but, that for whatever reason that would...
Hi, Yes, i've done a "show l2tp" and the result is: %No active L2TP tunnels. However, for whatever reason, it doesn't trigger as I've also included that in an EEM script as a test. Same thing to reboot as the previous script I posted, which I ...
