Hello GuysWell i have kind of problem with default route in EIGRP.I setup int loopback on core router with calassfull ip address (192.168.1.1/24 ) and do every then in global config by usingip default-network 192.168.1.0 set it up as default netwo...
Hello GuysWell i have kind of problem with default route in EIGRP.I setup int loopback on core router with calassfull ip address (192.168.1.1/24 ) and do every then in global config by usingip default-network 192.168.1.0 set it up as default netwo...
Hello dear friends .It's my second question on Cisco forum. I would like to know when we write some standard access list without wild card mask which range of ip addresses will be proceed?for example take a look at this one:access-list 3 deny 10.17.3...
I used other method which consider some route as default network ( it can be even a route to loop-back interface) .Well i just changed the router (in GNS3) and it already works. Thank you for your help
Thank your for your help.But i just changed the router type in GNS3 and it worked.I don't know why but it worked properly.The redistribution that you mentioned is the best way , but you know for for the sake of CCNP i must practice all the ways which...
Yeah i agree.But i am using second method which is setting some loopback interface classfull address then propagate it in EIGRP by using network command and then by using ip default-network command set in originating router set it as default network...
