Hi,the scenario is, when cisco VC (room kit) with tuch10 endpoints that registered to cucm, meet in a Webex meeting in the cloud. Q1: I choose that all participants will wait in the lobby. when I calling with my VC to my personal/schedule meeting ( t...
Hi ,
I'm looking for a way to work with e&m card on voice gateway 2900 when the VG is in srst mode . so when I'm dialing to number from out side and he is getting to the VG with the E1 card that he have on him it will pass to the E&M card (on th...
Hi ,
i have cwms on premise ver 2.5. it is for 250 user with one admin and one media .
whan i am on a voice conference on my lan and i am recording it seems ok but when i am going to my web portal to searce my recoed it is not there . if i will wait ...
Hi guys ,
Problem description:
When you disconnect or turn off a station connected to your phone, the MAC still appears in the port on the switch for a few minutes. When the station is directly connected to the switch, the MAC drops immediately upo...
Hello, thank you very much for that extension. I have just one question with another scenario that I am looking for an answer. Uccx ver 11 HA SITE A -ACTIVE finesse agents connecting to this server. when i disconnect the network leg from that ser...
I do what to register it with mgcp.
in Srst mode. the phones (sip,sccp) that register to the srst can dial to the e/ m.
I look for configuration docs but can not fine. some doc says that it cannot works.
can you point me to docs that help wi...
Hi,
start next week to configure that.
just for remained - my router is in mgcp protocol .there is a way to operate the e/m card in that status?
thanks sharon
