Hi Mats, Do a "sh pmk-cache " to see if the devices are showing up in the WLC's PMK cache. This shou...

Thank you Javier,Just saw the new update. Thanks for the new features!--Bruce Johnson

Hi Javier,Thanks for creating this great assessment tool.Some wish list items:1. Have the "Compensat...

Ok thanks. Interesting, so this wouldn't be anything the controller would see in a client debug. Did...

I managed to get one going here. Is the sniffer mode AP close enough to clients connecting to nearby...

That's right thank you. Any luck with the payload? Its been a while since I tried this.Sent from Cis...

What are you using as the decoder for the frames? Are you using the AIROPEEK transport protocol?Sent...

Thanks Rasika, No AAA AP auth in place. 186 APs are currently connected. The APs in question are all...

Seeing the same issue with 1140/7.4/5508 WLC: WLC debug capwap events log: *spamApTask7: Sep 24 11:4...

Thanks George,Absolutely. Looks like you are ready for some more certifications. The issue seen has ...

Right, so does this mean these would never L3 roam because its essentially a local auth (isn't WPA2-...

Scott,I have seen this behavior with iPhone as well, though with dynamic L3 roaming within a mobilit...

Thanks as always. Never hurts to be reminded. This is an edu site but points taken - and given Sent ...

Good point George. Have to make sure there's valid primary channels for "legacy"' 802.11a clients. I...