About Ally Moghimian

Ally Moghimian · 03-03-2022

Device: C2960-24PS-LLIOS Image to be loaded: c2960x-universalk9-mz.152-7.E5.binHave copied the file to flash, and it is listed. "Switch: Boot " returns the following: switch: bootLoading "flash:/c2960x-universalk9-mz.152-7.E5.bin"...Verifying image f...

Ally Moghimian · 09-04-2015

Hi,We have more than 60 switches and routers, with lots of different configurations.is there a Windows-based app/solution that allows administrator to automatically backup the current configuration (with/without version management) on a schedule?Rega...

Ally Moghimian · 06-20-2014

Hi,We have few Cisco 6921 phones currently registered with our CUCUM BE3000.We have migrated to a new AD DHCP server, but having problem with phones that are switched off and back on again. they don't simply register with the new DHCP server. CUCUM c...

Ally Moghimian · 10-28-2013

Hi,Got a new 24port 2960 switch to add to our existing infrastructure.Not sure where to start from. Would copying from the existing config on couple of other switches be an option? Or does it have to be from scratch, beside giving a new address, etc?...

Ally Moghimian · 07-16-2013

Hi,Got a brand new Aironet 1602e out of the box.It got it IP address from the DHCP address including the subnet and gateway.enabled dot11.0, set to throughput and assigned a wep key.assigned SSID and set it to guest mode.The client device (a barcode ...

Ally Moghimian · 03-03-2022

Many thanks for your input, do you mean COPY USBFLASH0: FLASH: is incorrect??

Ally Moghimian · 06-20-2014

that's very true!!! thanks for getting in touch anyway cheers,Ally

Ally Moghimian · 06-20-2014

Hi,we migrated DHCP records like-for-like. so there wasn't any need to modify the server apart from unauthorizing the old one and authorizing the new one. However, spent some time on our gateway switch and discovered that IP helper for the voice vlan...

Ally Moghimian · 10-30-2013

Andrew,thanks for your reply.That's pretty much what I had in mind. As you mentioned, it's for adding to the existing port capacity and should be relatively simple.cheers,Ally

Ally Moghimian · 07-17-2013

I managed to figure it out!I used your hint and checked out the WEP key. The Hex was encrypted and client settings were set to No-Encryption. I changed the keys and all seems fine.Thanks you all for the advice and the impressive response time!!

Member Since	‎07-16-2013 09:52 AM
Date Last Visited	‎03-09-2022 10:31 PM
Posts	11
Total Helpful Votes Received	10

User Statistics

User Activity

Boot fails when initiated from ROMMON

Automatic configuration backup software

Cisco 6921 - BE3000 - new DHCP server

new 2960 for the existing structure

why Aironet 1602e doesn't forward/pass IP addresses to clients issued by windows DHCP server?

Re: Boot fails when initiated from ROMMON

that's very true!!! thanks

Hi,we migrated DHCP records

new 2960 for the existing structure

why Aironet 1602e doesn't forward/pass IP addresses to clients i