Hi,
I am trying to create a wireless mesh between my house & my garage. The good news is the MAP (Garage AP), can see the RAP (Basement AP) & I have devices connecting wirelessly in the garage.
The new issue is I have some wired devices that I wo...
I am experiencing a slight issue that for whatever reason I can't seem to figure out. I have 5 Vlans Vlan 1 192.168.1.0 Network Management networkVlan 2 192.168.2.0 PC NetworkVlan 3 192.168.3.0 Wireless NetworkVlan 4 192.168.4.0 Network 2Vlan 250 19...
Hi,So here is my current setup & I am going to type this out as best as I can.I have a modem from my ISP (1 ethernet port) that is running on DHCP & a Cisco Asa5505 that is currently doing DHCP for my devices hooked up to my layer 2 switch on the 192...
The map is connected to a unmanaged switch at the moment. That is its intended setup as i have a couple of wired devices on that end that I would like to communicate back to my network at the house (Which is about 20ft away) over wireless if possible...
