Hi,
I replaced a Cisco 881 router with an ASA5506 firewall on a small network and now the users can't use their softphone application.
The softphone is locally installed application on the PC and it connects to a IP/phone service on Internet.It was w...
Hello,We rent an office place in a large campus. I have not thought so much about vtp settings etc and we have a stack of two 3750 switches and a few 2960 access switches. The 3750 switches are set in vpt server mode. They are in default configuratio...
Hi,I have a problem with a Cisco 881W.I can't access the service module. When I type "service-mdoule wlan-ap 0 session" I get the login prompt, type my username/password and then it just hangs and nothing happens.If I type wrong usernam/password I ge...
Hello,If I have two paths in my routing table with the same cost to a network.How can I prefer one over another?R 10.55.130.0/24 [120/1] via 10.254.3.3, 00:00:12, GigabitEthernet0/0.301 [120/1] via 10.254.3.1, 00:00:19, Gig...
Hi,I have two offices connected by a fiber. Each office are connected with a cisco 3750 and in the middle I have a cisco 2960G.I have several vlans and using trunk ports to pass through all vlans in the same fiber Cable.I want to monitor and see how ...
Hi Jon,Thanks for the info,cdp only show my 3750 switch. I have not configured any vtp password. I Think I will begin to set all switches to transparent mode, it feels more secure right now until I have talked to the people there we rent the connecti...
Hello Joseph,Thanks for the information, but isn't this a big security issue, can someone put their switchport in my "vlan 20" and access my resources? I believed that they configured the fiber Connection as a isolated connection, but now it seems to...
Hi, here it is.sh int trunk on 2960:#sh int trunkPort Mode Encapsulation Status Native vlanGi0/24 on 802.1q trunking 1Port Vlans allowed on trunkGi0/24 1-4094Port Vlans all...
Hi Manish,Thanks for they reply. What guide do you refer to?On the router I have configured "ip unnumbered vlan1" under the "interface wlan-ap0".Configured both command you suggested, but the problem remains.... you think it's broken?Regards,Johan