Hello,
I have an ASA 5520 in my central site serving as a VPN termination point, and in the remote office 2 Cisco 1941 routers and each one has a static public ip form a different provider. There is an HSRP in place on the LAN side of the remote offi...
Hello,Our company is looking to set up Cisco Telepresence between 3 locations connected with VPN (and also maybe enabled external calls).We already have a VoIP system in place, with Cisco Routers (2811 and 2901) serving as h323 gateways. My question...
Hello,I have Cisco 2811 router with 3 Lan to Lan tunnels configured, im trying to set up remote access VPN also, but when i do it crashes my L2L tunnels after a while. This is the current configuration:crypto keyring spokes pre-shared-key address 0...
Im trying to achieve load balancing with 2 ISP's, cable (dhcp) and ADSL. I have a cisco 2821 router with an HWIC-1ADSLI module.LAN is a single C class subnet. I have tried following this cisco advisory to the letter:http://www.cisco.com/c/en/us/suppo...
Hello,Our client ordered PenTest, and as a feedback they got recommendation to "Disable SSH CBC Mode Ciphers, and allow only CTR ciphers" and "Disable weak SSH MD5 and 96-bit MAC algorithms" on their Cisco 4506-E switches with CIsco IOS 15.0I have g...
Ok, you guys pretty much summed up my thoughts on this:)
I was planning to add a second peer on ASA, but im worried about "lingering" sessions that may prevent the failover to happen in a timely matter. First question that pops up is whether to disab...
If i close one link it takes 20 seconds of downtime and then ping goes without loses. In the end i decided to go with PBR, since the deadline for our project was surpassed.I set up acl that matched every other 32 adress block: 10 permit ip 192.168...
