About soodsandeep

soodsandeep · 07-26-2013

I have two MDS switches in 1 fabric. My Tape Drive is in VSAN 112 in sw1 and my host is in VSAN 1002 in sw2. I have shanged the VSAN ID of 112 on that port of Tape Drive to VSAN ID 1002. But still I cannot see tape drive in sw2 or the database is not...

soodsandeep · 07-29-2013

This worked from Fabric Manager:Add VSAN to allowed-active list. In Fabric Manager, choose Switches > Interfaces > FC Logical, select the Trunk Config tab, and set the Allowed VSANs field. Click Apply Changes.Thank you both for all the help you have...

soodsandeep · 07-29-2013

This is what I am getting:Miami-HDS9513-2# config tEnter configuration commands, one per line. End with CNTL/Z.Miami-HDS9513-2(config)# interface fc9/13Miami-HDS9513-2(config-if)# switchport trunk allowed vsan 12port already in a port-channel, no co...

soodsandeep · 07-29-2013

They all are part of Trunk its 4 Connections make 1 Trunk.I am lloking the prociedure now to modify the VSAN allowed list as its set currently, only 12 and I need to add 1002 in this list as well. I am expecting I have to do this in all 4 Ports. IT s...

soodsandeep · 07-29-2013

Anuther this I have noticed that the Trunk Ports between these two switches are only for Data VSAN 12 only. We have 6 Trunk ports [TE] ports they all saying Allowed VSAN 12. Question is: Can it be changed so that Tape VSAN 1002 traffic can be allowed...

soodsandeep · 07-29-2013

Problem Switch1:FCSW2(config)# sh zone status vsan 1002VSAN: 1002 default-zone: deny distribute: full Interop: default mode: enhanced merge-control: allow session: none hard-zoning: enabled broadcast: enabledDefault zone: qos: none broadc...

Member Since	‎07-26-2013 07:11 PM
Date Last Visited	‎08-18-2017 04:27 AM
Posts	7

User Statistics

User Activity

SAN Extn in Same Fabric - MDS 9513

Re: SAN Extn in Same Fabric - MDS 9513

SAN Extn in Same Fabric - MDS 9513

SAN Extn in Same Fabric - MDS 9513

SAN Extn in Same Fabric - MDS 9513

SAN Extn in Same Fabric - MDS 9513