Hello, is it possible to get information from Firepower 1140 device with Cisco ASA image to Cisco CSP Collector? When I do it via standard procedure of SNMP pull from ASA - it wont return any Serial Number - just basic info. I suspect it will be sam...
Hello, We have a CSP collector (version 2.8.16) and we are trying to discover APs which are connected to WLC. In a older discussion I read that its enough to add WLC and APs will be discovered automatically. But seems its not happening - I dont see ...
Hello,is it possible to manually add to collector information about Firepower 2110 (PID - FPR2110-NGFW-K9) and FMC-2500 (Firepower Management Centre)?I tried to scan it via collector and Firepower 2110 was identified as "octeon" device without any de...
Great - thank you very much. According to your info - I was able to setup access to FXOS for FPR2110 and CIMC for FMC and now I have all 3 missing devices at SNTC portal.Thank you again and really appreciate your help.
Hello,same issue here.I tested that from 4 locations (all across the world). I tested following feeds:https://www.perfigo.com/ise/provisioning-update.xmlhttps://www.perfigo.com/ise/posture-update.xmlI can reach the feeds from 1 location but other 3 a...
I already tried that when I was trying to bend the config of OSPF VPN config.
With OSPF neighbor command is following problem:
neighbor 192.168.1.2 ERROR: Neighbor address does not map to any interface
when 192.168.1.2 is IP address of remote end ...
